Help Center
< All Topics

Preparation and start of the app

Create the conditions needed for a successful training:

  • find a quiet room (mobile phone etc. switched off)
  • appropriate temperature of 20-22° C (68-72° F)
  • convenient seating
  • comfortable clothing

You should avoid all conditions that can make you sweat out of purely physical reasons, like intense physical activity before training or intense sunlight and heat. This could falsify your measured values. To obtain comparable results, you should try to keep your initial and ambient conditions constant through the series of training sessions.

In comparison with other biofeedback techniques, you will need fewer sessions for a reliable success. 6-10 sessions should be sufficient. To keep focused throughout the entire session, you should limit each session’s length to about 30 minutes. If you start feeling tired while training, you should shorten your sessions and practice more often instead.

Fixation of the Velcro-electrodes

Wrap the two electrodes around the upper or middle phalanges of your index and middle finger of the same hand. The dark lower side of the electrodes shall be in good skin contact. Using the non-dominant hand is advisable (e.g. the left hand for right handed people) because the skin tends to be a little less callused there. Attach the cables and wrap the tape another time around their clips to ensure a firm contact.

eSense Skin Response in use with a tablet

You should neither tape the electrodes too firmly where you would block blood circulation, nor too weakly so as to let them slip and move around. Put your hand down onto a comfortable support where it can rest.

Another note: If your values are below 1µS, the electrical contact through the clip is bad, or your skin is dry and maybe callused. Check the contact clips, or change your hand or the position of the electrodes if necessary. If the conductance is permanently bad, we have listed several tips in the FAQ for the eSense Skin Response to improve the conductance. Usually gel electrodes are necessary. Don’t continue with the training if the values are below 1µS and solve the cause first.

The next step is to start the app. At the beginning you can choose between a free training and a procedure. We recommend that you start with a procedure. We present you both below.

Wählen zwischen Prozedur oder freien Trainings nach Start der App

Back General notes
More General view & Open Training
Questions

Leave a Question

Your email address will not be published. Required fields are marked *